Installation Instructions

All adjustments can be performed using a standard screwdriver, without removing the hinge from the door or jamb:

​

• Vertical Adjustment: ±2.5 mm
  (Adjustment screws located on the jamb side – two locations)

• Horizontal Adjustment: ±2 mm
  (Adjustment screws located on the door side – two locations)

• Depth Adjustment: ±1 mm
  (Adjustment screws located on the jamb side – two locations)

Always ensure that all fixing screws are tightened after alignment to maintain proper function and hinge integrity.

The locus chart defines the hinge’s movement path and required installation clearances:

​

• The hinge opens a full 180° with minimal clearance requirements.

• The door reference surface must align with the jamb reference surface for smooth, interference-free operation.

• A corner radius of C1 or R1 or greater must be applied to the inside edges (marked ※ in the diagram) to avoid mechanical interference during opening/closing.

• Ensure a minimum pivot clearance of 8 mm is maintained in the hinge area.

Proper alignment of reference surfaces is essential to prevent binding and ensure long-term performance.

Precise cut-outs are crucial for proper hinge installation and concealed functionality. The door and jamb cut-outs are identical and must be aligned with their respective reference surfaces.

​

Door & Jamb Cut-Out Specifications:

• Height: 120 mm

• Width: 25 mm

• Corner Radius: R6 (8xR6)

• Depth: 21 mm

• Setback: 23 mm from door edge / 25 mm from jamb edge

Ensure cut-outs are clean, square, and burr-free for a flush fit. Poorly prepared recesses may compromise hinge performance.